View Single Post
  #1  
Old 05-26-2016, 09:07 PM
Scrambled's Avatar
Scrambled Scrambled is offline
Master Fabricator
 
Join Date: Jan 2010
Location: KY
Posts: 459
Need help[ with Bend-Tech pro

I just ruined 2 pieces of pipe by not paying attention. OOPS.

I was trying to make 2 bends at both ends of a piece of pipe. The first bend was fine, the second bend, the remaining length of pipe was too short, and the pipe would have come off the following die block.

Is there a way for Bend Tech to tell me I need to add more length?

I normally catch these problems, but not tonight.


Steve
Reply With Quote