OFN Forums

OFN Forums (http://www.offroadfabnet.com/forums/index.php)
-   Race Car Fabrication (http://www.offroadfabnet.com/forums/forumdisplay.php?f=130)
-   -   Thinnest 1.5" tube for clean 6" bends? (http://www.offroadfabnet.com/forums/showthread.php?t=16365)

R3Fab. 01-12-2021 01:40 AM

Thinnest 1.5" tube for clean 6" bends?
 
Need to form up a 1.5" mild steel tube structure that is mostly to support the fiberglass body.
Not really structural as it is a ladder frame.
How thin may I go on a 6" centerline without undue risk of kinking?

Maxx Levell 01-12-2021 04:43 PM

What kind of bender? I've done 180 bends on .120 wall with JD2 Model 3. Never tried anything thinner than that on MS. Sounds like you're wanting thinner than that though lol.

R3Fab. 01-14-2021 12:57 PM

Yes, JD2 M3.
I need to keep the build as light as possible with the exception of the roll hoop.
1.5" as that is the only 6" CL die I have.

TheBandit 01-15-2021 12:57 PM

Based on the recommended wall thickness range they provide below for 5.5CLR and 6.5CLR dies, the min is going to be somewhere between 0.065 and 0.083. Thinner is just going to flatten out more and be more difficult to weld. Even on a ladder frame, I'd error toward the thicker side unless you want to spend time reinforcing any structural connections. My brother has built a few manx-style buggies and vw sandrails out of 1.5x0.095 HREW. I've noticed over time lower members like bumpers and siderails end up with dents. DOM would be a better bet IMO.

https://www.jd2.com/model-3-die-set-...und-tube-15-od

Graham08 03-17-2021 01:22 PM

I know this is probably too late to be helpful, but 0.065" works well on a 6.5" CLR with my JD2 bender. I have done 0.058" 4130 but it can be dodgy. One stick will bend fine, and another will wrinkle or collapse altogether.


All times are GMT -4. The time now is 08:16 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright ©2012-2020, Offroad Fabrication Network